[Graphics Card] Level Sense in GPU Tweak III

Level Sense helps ensure your card is perfectly level. This feature uses onboard sensors to detect GPU sag, prompting adjustments to prevent unsightly drooping and potential damage.

 

Supported Models: ROG-MATRIX-RTX5090 Series, ROG-ASTRAL-RTX5090 Series, ROG-ASTRAL-RTX5080 Series

 

1. Initial Setup of Level Sense in GPU Tweak III

Step 1: Launch GPU Tweak III, and click "Level Sense".

 

Step 2: You can set the threshold value once the graphics card is current installed; otherwise, click the Calibration button to perform calibration.

 

Step 3: Set the Threshold Value and Save. (The default value is 0.30 degrees. A smaller value makes the alert notification more sensitive.)

 

 

2. Adjusting Level Sense in GPU Tweak III

 

Step 1:  Adjust the value and click Save or Recalibrate.

Recalibrate:

 

 

 

3. Alarm Message

 

When the graphics card exceeds the threshold value in GPU Tweak III, the alert shown below will appear. 

At this point, we recommand reinstalling the graphics card to prevent potential issues.

 

Alarm message in Level Sense:

 

Alarm message in GPU Tweak III:

 

 

When GPU Tweak III is running in the background, alarm messages will appear in the system’s notification area (bottom-right corner).

 

Note: When an unusual graphics card installation angle is detected, the following message will appear, recommending that you reinstall the graphics card.

 

 

Q & A

 

Q1. Calibration failed. How can I troubleshoot to ensure successful calibration?
A1: To ensure calibration accuracy, the process must be performed in a stable environment. If calibration fails, it may be related to environmental stability.

 

．Please check that all components inside the chassis (such as fan screws, liquid cooling brackets, or drive cages) are securely fastened to avoid vibration interference during calibration.

 

．Ensure the computer is placed on a stable, flat surface, and perform the calibration again when the system is under low load and minimal vibration.


Q2. The software keeps showing alerts. How can I resolve this?
A2: The default threshold for Level Sense detection is set to 0.3. If the threshold is set too low, external environmental factors may trigger frequent alerts.
You can adjust the threshold based on your specific usage environment.