[Troubleshooting] What to do if AiMesh synchronization fail? | Official Support

ASUS Support FAQ

FAQ

Product GT-AC5300, GT-AX11000, RT-AC1900, RT-AC1900P, RT-AC1900U, RT-AC2900, RT-AC3100, RT-AC5300, RT-AC68P, RT-AC68R, RT-AC68RW, RT-AC68U, RT-AC68U V2, RT-AC68U White, RT-AC68UF, RT-AC68W, RT-AC86U, RT-AC88U, RT-AX88U

[Troubleshooting] What to do if AiMesh synchronization fail?

For more information and supported firmware downloads for AiMesh, please go to: https://www.asus.com/Microsite/AiMesh/en/index.html

Please follow the steps below and try the synchronization again:

1. If someone else also set up AiMesh system at the same time as you, please wait for 1 minute and try the set up again.

2. Position your AiMesh router and node within 3 meters of each other when running the setup process.

3. Check if your AiMesh node is powered on.

4. Be sure your AiMesh node is upgraded to AiMesh-supported firmware.

5. Be sure your AiMesh node is reset to default.

Was this information helpful?

Yes No

Contact Support

Please contact with us if the above information cannot resolve your problem

Above information might be partly or entirely quoted from exterior websites or sources. please refer to the information based on the source that we noted. Please directly contact or inquire the sources if there is any further question and note that ASUS is neither relevant nor responsible for its content/service
This information may not suitable for all the products from the same category/series. Some of the screen shots and operations could be different from the software versions.
ASUS provides the above information for reference only. If you have any questions about the content, please contact the above product vendor directly. Please note that ASUS is not responsible for the content or service provided by the above product vendor.
Brand and product names mentioned are trademarks of their respective companies.

ASUS Support FAQ