[Desktop Chassis] ROG Z11 Case FIO Module Replacement

Note

  • Please put the case on a flat table to prevent the side panel from falling during disassembly and assembly. 
  • Please handle with care when disassembling and assembling the glass side panel to avoid collision/drop/heavy pressure.

 

 

Preparation

Tool:  Phillips screwdriver PH2

 

1.Remove the top and lower panels, left and right-side panels, and then remove the filter.

2.Loosen the front I/O module connector to the FAN HUB and release the cable tie.

 

3.Loosen the two screws on top of the front panel.

 

4.Loosen hidden safety screws.

 

5.Lift up the panel, attention     
   (1)The plastic buckle may be a little tight, you need to use a little force.     
   (2)There are light cables connected to the panel, so be careful not to lift it up too high.

 

6.Remove the panel by pulling out the light board cable. Loosen the plastic back cover screws of the front I/O module and remove the back cover.

 

7.Remove the front I/O module by loosening the front I/O module screws.