[SSD Enclosure] How to install SSD into ProArt PA40SU SSD Enclosure?
This guide outlines the steps to install an SSD into your ProArt PA40SU SSD Enclosure.
Notice：Please visit the product's Tech Specs page to check SSD compatibility.
Steps to Install an SSD in ProArt PA40SU
1. Slide the latch on the rear of the enclosure and lift to remove the back cover.
2. Rotate the Q-Latch to the SSD installation position.
3. Install your M.2 SSD. (For this example, a 2280 size M.2 SSD is used.)
3-1 Insert the M.2 SSD into the slot.
3-2 Rotate the Q-Latch clockwise to secure the SSD.
4. Reattach the enclosure cover. Press gently until an audible "click" confirms the cover is securely sealed.
Steps to Move the Q-Latch to Fit Your SSD Size
1. Rotate the Q-Latch clockwise.
2. Move the Q-Latch downward to the lager hole below.
3. Remove the Q-Latch.
FAQs
Q1. Which SSD form factors are compatible with the ProArt PA40SU Series?
Answer: The ProArt PA40SU Series supports M.2 NVMe PCIe SSDs in 2230 and 2280 form factors, featuring an M-key interface and capacities up to 4TB.
Q2. Why can't I remove the Q-Latch?
Answer: To remove the Q-Latch, ensure it is rotated to the correct position. (as shown in the illustration) and then push down to remove it
For more information, please visit product site .ProArt PA40SU｜Data Storage｜ASUS Global