BIOS & FIRMWARE
- Driver & Tools
- BIOS & FIRMWARE
Enhance the compatibility with certain memory.
Support new CPUs. Please refer to our website:http://support.asus.com/cpusupport/cpusupport.aspx?SLanguage=en-us
Support new CPUs, please refer to our website: http://support.asus.com/cpusupport/cpusupport.aspx?SLanguage=en-us
Add support for new CPUs, please refer to our website: http://support.asus.com/cpusupport/cpusupport.aspx?SLanguage=en-us
1. Fix CPU ratio will not reset after load BIOS default
2. Enable support for N/2 Ratio option
1. Support new CPUs. Please refer to our website at: http://support.asus.com.tw/cpusupport/cpusupport.aspx
2. Update CPU temperature low limit form 1.1V to 0.85V
3. Finetune Q-Fan control code
1. Finetune CPU temperature detection algorithm
1. Enhance memory compatibility under FSB1333 mode
1. Add new CPU uCode to support new processors
2. Revise SLP 2.0 rule
3. Support SATA Hot Plug function under AHCI mode
4. Fix after downgrade CPU ratio, the Conroe L frequency not correct under ASUSCPU
5. Enhance USB device compatibility
**Please update AsusUpdate to V7.09.02 or later prior making this update.**
**Do not use AsusUpdate to downgrade BIOS. For such need, please use EZFlash or AFUDOS instead**
1 Enhance memory compatibility
2 Support CONROE E0 CPU(FSB 1333)
1. Update Jmicron option ROM to 1.06.59
2. Fix AC Power loss function not correct
3. Support x4 DIMM
4. Moidfy Write to Precharge Delay default from 10 to 11
5. Enable support for EIST under VISTA
6. Finetune Q-Fan rule
7. Support SLP 2.0
8. Fix BBS device string not correct under AHCI mode
9. Enable Disable USB capability
10.Support ASUS WIFI-TV card
11.Revise CPU temperature calculation algorithm for PECI
1. Support conroe L processor
2. Update JMicron option rom 1.06.22
3. Modify CPU fan low limit speed from 800 RPM to 600 RPM
1. Patch system will hang at post code 0FFh when FSB over 321
2. Enhance Chassis Q-Fan sensitivity
3. Enhance memory compatibility
4. Fix CPU frequency not correct when use ES CPU and lock free fuction enable
Initial Release