[Gaming Cases] TUF Gaming GT301 FIO Module Replacement Instructions | Official Support

ASUS Support FAQ

FAQ

Product TUF Gaming GT301 Case

[Gaming Cases] TUF Gaming GT301 FIO Module Replacement Instructions

[Notice] Do not pick TUF Gaming GT301 case up by the front fabric straps.

1. Preparation

Phillips Screwdriver PH2

2. Remove FI/O Module

(1) Hold the notch at the bottom of the front panel (Remark 1) and pull it up(Remark 2), then remove the front panel

(2) Remove two screws on the front (Marked in red)

(3) Remove two screws near the top cover(Marked in red). It is recommended to place the case upside down for easier removal of screws.

3. Install Front Panel

After I/O module is replaced, ensure all screws are locked. Press the two clips on the top of front panel back in place (Remark 3), and press two clips on the bottom of it back in place.(Remark 4). Now we have front panel installed.

For product info, please visit https://www.asus.com/Motherboards-Components/Gaming-Cases/TUF-Gaming/TUF-Gaming-GT301/

Was this information helpful?

Yes No

North America Contact Support

If you need more help, see our solutions to get support.

Above information might be partly or entirely quoted from exterior websites or sources. please refer to the information based on the source that we noted. Please directly contact or inquire the sources if there is any further question and note that ASUS is neither relevant nor responsible for its content/service
This information may not suitable for all the products from the same category/series. Some of the screen shots and operations could be different from the software versions.
ASUS provides the above information for reference only. If you have any questions about the content, please contact the above product vendor directly. Please note that ASUS is not responsible for the content or service provided by the above product vendor.
Brand and product names mentioned are trademarks of their respective companies.

ASUS Support FAQ