ASUS ProArt Calibration
*If you want to install this version, please uninstall the old version before installing it.

New Features:
1. Added support for the PR788 series calibrators.
2. Added a calibration pattern size setting to Software Calibration.

Remove Features:
1. Spyder V is no longer supported starting from this version.

Fix & Improvement:
1. Improved low-luminance measurement stability of CaliContrO MCA02. (Requires CaliContrO MCA02 firmware MCM105 or later)
2. Corrected the names and contents of Preset Mode and CAL Mode.
3. Optimized the calibration alignment frame and user interface.
4. Migrated the application to a native 64-bit (x64) architecture for improved performance and system stability.
5. Fixed an issue where PA27UCX/PA32UCX/PA27DCE could not be connected.
6. Fixed an issue where multiple PA32UCDM/PA32UCDMR/PA27UCDMR monitors could not be connected at the same time.

Limitation:
1. CR250/CR300 do not yet support user selection of calibrator profiles.

*If you want to install this version, please uninstall the old version before installing it.
New Features:
1. Add calibration estimated time and calibration progress bar indicator.
2. Added support for specifying an SN to select which monitor to calibrate when multiple units of the same model are connected.
3. Add a “Relative Gamma” option to the calibration target EOTF in User Mode.

Fix & Improvement:
1. HDR report now uses Delta ITP.
2. Add a 24-hour waiting mechanism for appointments to avoid conflicts.

*If you want to install this version, please uninstall the old version before installing it.
Fix & Improvement:
1. Fix the accuracy issue for Embedded Calibrator Correlation function for PA27USD, PA32USD, and PA27UCGE.